The solution to the weak connector of the customized 1000V DC Contactor in china_Vacunm | DC contactor |XGVAC Technology (Shanghai) Co., Ltd.

新闻资讯

The solution to the weak connector of the customized 1000V DC Contactor in china

Release time:

2022-08-08 08:00

1. For the connection of the customized 1000V DC Contactor in china is not firm due to oil stains, scratches or other stains on the DC contactor, you can clean the stains with pure cotton cloth dipped in ethanol or gasoline.
2. If the touch surface of the customized 1000V DC Contactor in china is converted into an air oxide layer or slightly burned and blackened under the effect of electric isolation, the connector is not firm, it is also possible to use ethanol, automotive gasoline or carbon tetrachloride water solution. Clean up stains.3. The surface of the customized 1000V DC Contactor in china is burnt out and uneven, you can use a fine file to eliminate the splashing beads or vibration lines around it, and do not file too much to prevent the service life of the contactor from being jeopardized.
4. For DC contactors, if the degree of the customized 1000V DC Contactor scalding is minor, just use a fine file to repair and level the unevenness, but it is not allowed to use a fine sand cloth to polish and polish, so as to prevent the quartz sand particles from falling into the contactor and causing the contact to fail.and stablize.
5. If the damage of the customized 1000V DC Contactor in china or is serious and the surface is depressed, be sure to replace it with a new contactor. If the contactor is still partially blocked during operation, the contactor can be disassembled and repaired.